GLOMEX VHF - AIS - RADIO SPLITTER 12V

GLOMEX VHF - AIS - RADIO SPLITTER 12VVHF/AIS/Radio Splitter - 12VDC
The RA201 splitterallowsthe use of just one VHF antenna to simultaneously receive VHF, AM/FM and AIS radio signals; without sacrificing performance on the VHF transceiver. Thiscompact, economical and innovative device can be easily installed in any place. It requires only a 12Vdc power source with a maximum of just 25 mA power consumption. The unit comes with a coaxial input from the VHF antenna and three outputs for VHF, AM/FM radio and AIS. Thanks to an electronic circuit specifically developed by Glomex and the presence of a built-in preamplifier, the RA201 splitter is able to offer high performance in all three applications, ensuring effective transmission and reception for VHF.

The splitters maximum input power for VHF is 100 watts, twice as much as most devices on the market.
Specifications:
Impedance: 50
OhmFrequency of radio reception: 100 KHz to 200 MHz (GO/PO/OC/FM included)Frequency of transmission/reception
VHF: 100 MHz to 200 MHz (marine/ham radio)Frequency of
AIS reception: 100 MHz to 200
MHzBuilt-in preamplifier: 15dB shared on two inputs (to compensate power loss)
VHF power range: from 0.2 watts min to 100 watts maxMaximum power consumption: 25
mAVoltage source: 13.8 V (from 10 Vdc min. to 16
Vdc max)Cable supplied: 60 cm (2) red (+) and black (-)Protection: Fast blow fuse 520 mm -315 mA (included)
Connections: VHF
antenna: SO-239
jackVHF: RG-58 C/U cable 60 cm (2) + male
PL-259 connectorRadio: RG-59 A/U cable 60 cm (2) + male
Motorola connectorAIS: RG-58 C/U cable 60 cm (2) + male
BNC connectorHousing: length 83 mm (3 ) x width 48 mm (2) x height 38 mm (3 ) Anti-spreading metal-epoxy paint, high resistance to rust and oxidizationMounting: by
4 each 4mm screwsConnections: Connect the antenna cable with a PL-259 connector to the splitter RA201 S0-239 jackConnect the marine VHF radio to RA201 using the marine VHF radio cable of RA201Connect the AM/FM radio receiver to RA201 using the AM/FM radio cable of RA201Connect the AIS receive only to RA201 using the AIS receiver cable of RA201Connect the splitters power supply (can be hooked to boats accessory panel)
Remarks: Make sure that power supply polarities are not reversed: red to positive (+) and black to negative (-)Do not use without first connecting the VHF antennaDo not reverse the connectionsONLY FOR RECEIVER ONLY AIS DEVICES. NOT SUITABLE FOR AIS TRANSPONDER DEVICESWARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings. ca. gov.
Type: Misc