Helmet Chin Mount Kit Compatible with GoPro Hero 87 201865 Black4 Session3+ Action Camera and More

The chin assembly can be mounted on either side of the helmet's chin, front and rear of the helmet, or on the top of the helmet. The wrench in the package can be used to assist the set screw. The helmet chin mount is with extension which can swivel 180, so you can adjust to wide range angles, such as forward visibility, backward visibility and blind area. This product uses a strong double-sided sticker that can be tightly attached to the helmet. Use the included safety buckle and attach it to the side to provide double protection for your action camera.

You can combine the J-hook mount with curved mount to use it on helmet or combine it with flat mount to use it on ski/skate/surf boards, kayak and so on. The sticky pad can be removed by peeling it off from the edge, or be removed cleanly after heating with the hair dryer. HOW TO USE IT?
Step 1: Rip the double-sided tape onto the slide base.
Step 2: Adjust the bracket angle in advance and align the position where the helmet should be attached.
Step 3: Attach the bracket to the base.
Step 4: Hang the safety buckle at the camera and bracket interface.
Step 5: Attach the safety buckle to the other side of the chin.
Step 6: Install the camera and tighten the screws on the bracket with a wrench.
Specification:
Material: Plastic
Suitable for: GoPro Hero 6 Black, Hero 5 Black, Session 5/4, 4 Silver, 3+, AKASO/Campark/Crosstour/APEMAN action camera, SJ4000/5000/6000, Xiaomi YI/4K, LD4000/6000, Sony Sports DV, etc.
Product Includes: 1*helmet chin mount 1*J-hook 2*Curved mounts 2*Flat mounts 10*Sticky pads 2*Screws 1*Safety rope buckle 1*Wrench 1*S-adapter 1*Release buckle
Note: The camera and helmet are not included.