TRONXY's new TR sensor can detect all non-transparent objects, 3D printer kit parts, focus detection, automatic leveling + mesh glass 400*400mm

1. Innovative Solenoid: Ultra Power Saving On idle state, while the push-pin is whether pulled out or retracted, there are not any electric current flowing on solenoid, and standby electric current in the whole device is below 15mA on average, whereas on working state, while the pin is moving in sudden about 100ms, under 300mA flows in the device. Low power consumption even further drops joule heating, preventing from heat problem. 2. wide Selection of Bed TR Sensor does not uses either optical, nor proximity (inductive/capacitive) sensor. TR Sensor is controlled by Hall Effect, providing high precision. Thus the bed material can be selected freely. 3. Optimized structure: Larger Build Size TR Sensor is a small and technology-intensive one. Build size can be set larger than other existing auto bed leveling sensor. TR Sensor uses existing RC Servo motor signal intactly, so just plug 3DTouch on the same pins after removing servo motor. Specification: Detection distance: 8mm Working voltage: DC 6-36v Interface: 3 pins Cable length: about 120cm Lattice Glass Plate 1, Leveling is made on A4 size paper to the platform and nozzle, which is obviously obstructive but can be pulled. 2, The platform has serious pollution will affect the adhesion, appear this kind of circumstance can be hot bed heated to 90 degrees, or place your platform for 8 hours to print again, the most direct method using alcohol to wipe a little bit. 3, Printing temperatures of various filaments: PLA50-65°C, TPU40-60°C, ABS80-120°C, PC100-125°C, PETG70-90°C, and NYLON 100-130°C. 4, This product is acid and alkali resistant, and high temperature resistance is 400 degrees. 5, The hardness of the first layer of coating of this product is 0.5H, which is easy to scratch, but the scraping does not affect the adhesion of the model. 6, The product will change color after many times rubbing with alcohol, but it will not affect normal use. 7, This product is slightly after wiping with alcohol can enhance the viscosity of the platform and the ability to absorb the oil, if you want to make a large models for a long time, can use a paper towel or cloth dipped into alcohol wipe slightly, so that we can ensure that the platform power ability to continue playing.(just rub it with alcohol once. You don't need to rub it every time when you strat print it. Repeated rubbing will not increase the stickiness. 8, Avoid repeatedly touching the platform with your hands as much as possible to prevent serious sweat oil on the platform. 9, This product is treated with special technology, and there will be no glass pit. Package list: Plate Clamps × 4 Screw ( M3 15mm ) × 2 TR Sensor with 120mm Cable1 × 1 400*400MMLattice Glass Plate1 × 1