50 ft Low-Loss Coaxial Extension Cable (50 Ohm) N Male to N Male Connector, Pure Copper Coax Cables for 3G/4G/5G/LTE/ADS-B/Ham/GPS/WiFi/RF Radio to Antenna or Surge Arrester Use (Not for TV)

Size: 50 ft Double shielded coaxial extension cable made of low loss S-LMR400 sized pure copper coax cable.
Specifications: -
Connector 1: N Male plug w/ Gold-Plated pin (50 ohm) -
Connector 2: N Male plug w/ Gold-Plated pin (50 ohm) -
Length: 50 feet (16 Meters) -
Impedance: 50 Ohm -
Coax: Double shielded Low-loss S-LMR400 size ( 10.3 mm/ 0.4 inch diameter) -
Operating temperature: -40C ~ +85C. - Minimum coiling diameter is only 1.5 inches. - 90 degree bends in one inch or less without loss. S-LMR-400 S-LMR400 is an excellent cable for runs up to 50-70 feet in WiFi and Cellular use, and provides superior performance for HF/VHF/UHF installation up to 250 feet. S-LMR400 Coax is the same size as RG-8U or RG-213 cable, 0.405 inches in diameter. A larger cable means a much larger center conductor and supports better signal retention for higher frequency use. S-LMR400 assemblies are a drop-in replacement for RG-8/9913 Air-Dielectric type Cable and are ideal for Jumper Assemblies in Wireless Communications Systems, Short Antenna Feeder runs, and any application requiring an easily routed, low loss RF cable.
Application: Use to connect N radio sources such as modem, routers, WiFi Signal Booster Repeater, etc. to the N-Female connector found on many external fixed mount antennas (e. g. fiberglass omni-directional, directional panel, sector), receivers, meters and radio transmitters. Coaxial jumper cable to connect between N-Female antennas, amps, routers, radioss, lightning suppressors and WiFi signal booster repeater, etc.
Package List: 1 x N Male to N Male Low Loss Coaxial Cable (As the Picture Shown)