Audio IC Development Tools Stereo 3.7W Class D Audio Amplifier (1 piece)

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V - 5.5VDC. Since the amp is a class D, its incredibly efficient (over 90% efficient when driving an 8O speaker at over a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. This board is a welcome upgrade to basic "LM386" amps! The inputs of the amplifier go through 1.0 uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the R- and L- to ground.

The outputs are "Bridge Tied" - that means they connect directly to the outputs, no connection to ground. The output is a 360KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly. Comes with a fully assembled and tested breakout board with 1.0 uF input capacitors. We also include header to plug it into a breadboard, 3.5 mm screw-terminal blocks so you can easily attach/detach your speakers, and a 2x4 header + jumper to change the amplifier gain on the fly.

You will be ready to rock in 15 minutes! Speakers are not included, use any 3ohm or greater impedance speakers.
UPC: 720189972874
SKU: ADIB00N42NP6W