Upgraded 30A 12V/24V Auto Volt/Amp/Temp Display PWM Solar Panel Charge Controller

Features:   - With Voltage & Current & Temperature Display - Support detection for the Vpmax for the panel, Not just charging voltage. - 32 bit MCU high-speed kernel ARM CORTEX, CPU running speed 72MHz - 13 new function LCD menu, Adjustable charging parameters. - One-click to restore factory Settings, One-click to reboot. - Fully 3-stage PWM charge management. - Build-in short-circuit protection, open-circuit protection, reverse protection, Over-the-load protection. - ST/IR/ Infineon imported dual MOS MOSFET for anti-reverse circuit - 1oZ copper foil thickness, applicable in -35?~60?, high-temperature protection. - Use ± 1% high precision resistance, the high-temperature solid-state capacitor on the PCB board with thickness over 2mm.   - Ultra-low power consumption 12mA@12V. - Double USB 5V 2A.
  Applicable Battery Type:   - 
B01: lead-acid battery ( 13.7V )   -
B02: lithium polymer battery ( 12.6V )   - 
B03: lithium iron phosphate battery ( 14.4V )   Specification of 30A
Controller:  
Rated Voltage: 12/24V Auto-Adaptive
Rated Current: 30A Applicable Pmax & Voc in 12V
Solar System: 390W, 15-25V Applicable Pmax & Voc in 24V
Solar System: 780W, 30-50V
Equalization: 14.4V
Float charge: 13.7V (defaul, adjustable)
Discharge stop: 10.7V (defaul, adjustable)
Discharge reconnect: 12.6V (defaul, adjustable)
Charge reconnect: 13V
Voltage of open light: Solar panel 8V (Light lights delay)
Voltage of close light: Solar panel 8V (Light off delay)
USB output: 2 way USB output, 5V/2A(Max.
) Self-consume: <12mA Operationg temperature: -35-60? Size: 132mmx70mmx32mm   About the Charging & Dis-Charging Current Display:   - The controller is mainly designed for the high current solar system, The current may not display in 3 situations: Low-wattage panel, Weak sunlight, Low-wattage appliance.   - The display is more accurate when the current is higher (> 1A).   About the
Temperature Display:   Charging will stop at >80?   Charging will restart at <70?   System connection:  
1. Connect the battery to the charge regulator-plus and minus.  
2. Connect the photovoltaic module to the regulator-plus and minus.  
3. Connect the consumer to the charge regulator-plus and minus.
  Package included:   1 x PWM Solar Charge Controller 30A 1 x User Manual